Hi,
I have 2 DA servers, both with 2 NICs (1 in DMZ and 1 on the internal network). The second server has had the DA role installed, but not configured. I want to configure load balancing in the following manner:
- External\DMZ NIC using NLB
- Interbal NIC using a hardware load balancer
All of the GUI and PowerShell options I've seen want to use the same load balancing method for both the internal and external interface, what I don't know is how to configure load balancing to accomodate a mixed load balancing setup?
In addition, I'm looking at using manage out with limited isatap applying to a single server, this server will then be used to RDP, remote assist, etc clients. I'm planning on following the process listed here: https://www.packtpub.com/books/content/configuring-manage-out-directaccess-clients. The manage out server will be on the same VLAN as my DA servers and clients connect to the DA servers via ip-https. What I would like to know is if I need to open any additional ports between my manage out server to the DA clients? My understanding is that using limited isatap, the manage out server's ipv6 traffic is routed via the DA servers and encapsulated in ipv4 over the internet, so therefore no additional ports need to be open, other than say 3389 on the DA client?
Thanks
I have 2 DA servers, both with 2 NICs (1 in DMZ and 1 on the internal network). The second server has had the DA role installed, but not configured. I want to configure load balancing in the following manner:
- External\DMZ NIC using NLB
- Interbal NIC using a hardware load balancer
All of the GUI and PowerShell options I've seen want to use the same load balancing method for both the internal and external interface, what I don't know is how to configure load balancing to accomodate a mixed load balancing setup?
In addition, I'm looking at using manage out with limited isatap applying to a single server, this server will then be used to RDP, remote assist, etc clients. I'm planning on following the process listed here: https://www.packtpub.com/books/content/configuring-manage-out-directaccess-clients. The manage out server will be on the same VLAN as my DA servers and clients connect to the DA servers via ip-https. What I would like to know is if I need to open any additional ports between my manage out server to the DA clients? My understanding is that using limited isatap, the manage out server's ipv6 traffic is routed via the DA servers and encapsulated in ipv4 over the internet, so therefore no additional ports need to be open, other than say 3389 on the DA client?
Thanks
IT Support/Everything