Hi.
Directaccess from a Windows 10 client works fine to all Windows Server 2012 R2 servers and to PCs and other IPv6 and IPv4 devices, but cannot connect or ping to two Windows Server 2008 R2 servers in the same location. Names are resolving to addresses.
Servers are a mix of real and Hyper-V.
One of the 2008 R2 servers was built fresh just for troubleshooting this issue.
As you would expect, the DA Client Troubleshooter reports all green. I suspect some additional configuration is required but some hours of searching have not got me there.
I am new to DirectAccess so please speak slowly:-)
Many thanks in advance
Scott
Additional information: One 2008 R2 server was previously a real (tin box) server and was accessible from DirectAccess. Since being virtualised it became inaccessible.
Sorry if watchers are getting lots of notifications from my edits.