HI
I am using Directaccess on my Xen Server and its working fine.
the current Remote Access Server Setup are (Behind an Edge Device (With Two network Adapters)
Recently I migrated DA to VMWare ESXi
I reconfigure the drivers and IP/Routes and the server is reachable and seems to be OK
but directaccess is not working.
when I open the DA Console \ Remote Access Setup I notice the following
The Default option is Behind an Edge Device (with a Single Network adapter) and the options are disabled.
The Server have 2 Network interface and the drivers and the tools are installed.
what should i do to correct this behavior.