Hey everyone
We have uag 2010 installed to publish our SharePoint Portal in the internet. Since the installation auf the UAG SP2 and afterwards SP3 we are getting strange errors. If someone wants to open an office document (read or write) the document itself in the office application (e.g. Word) shows an uag error: you have attempted to access a restricted url, the url contains an invalid parameter.
uag webmonitor shows the following four errors:
A request from source IP address xxx.xxx.xxx.xxx, user on trunk xy; Secure=1 for application SharePoint-Portal of type SharePoint14AAM failed because the method used HEAD is not valid for requested URL /hilfe/HotFix%20zu%20Portal/MacOS%20an%20WLAN.docx.
A request from source IP address xxx.xxx.xxx.xxx, user on trunk xy; Secure=1 for application Internal Site of type InternalSite failed because the method used HEAD is not valid for requested URL /InternalSite/InitParams.aspx?referrer=/InternalSite/InternalError.asp&site%5Fname=bzzs&secure=1&error%5Fcode=22&policy%5Fid=&ErrorType=HTMLErrorPage.
A request from source IP address xxx.xxx.xxx.xxx, user to trunk xy; Secure=1 for application SharePoint-Portal of type SharePoint14AAM failed. The endpoint device does not comply with access policy settings (Hybrid_Default_Session_Access) for session F2E4F740-20F6-407A-9C85-37B278F54736. The URL is /hilfe/HotFix%20zu%20Portal/MacOS%20an%20WLAN.docx.
A request for application Internal Site of type InternalSite on trunkbzzs; Secure=1 failed. The URL /InternalSite/InitParams.aspx?referrer=/InternalSite/InternalError.asp&site%5Fname=xy&secure=1&error%5Fcode=25&policy%5Fid=Hybrid%5FDefault%5FSession%5FAccess&ErrorType=HTMLErrorPage was rejected by the URL inspection rule InternalSite_Rule54. The reason for the failure: Parameter value failed 'Value' check. The method is GET. The source IP address is xxx.xxx.xxx.xxx. The user is .
in the windows event viewer I additionally see the event id 51. Has anybody a solution?