I am trying to setup the DirectAccess Connectivity Assistant per the Solution Accelerator "Deploying, Managing, and Using the Microsoft DirectAccess Connectivity Assistant".
Does anyone know where to find the DTE Tunnel IPv6 Addresses?
DTE
Type: A collection of IPv6 addresses that each identify a DirectAccess server.
Default: None
Description: Specifies the dynamic tunnel endpoints (DTEs) of the IPsec tunnels that enable DirectAccess. It is through these tunnels that the DCA attempts to access the resources that are specified in the CorporateResources setting. By default, the DCA uses the same DirectAccess server that the DirectAccess client computer connection is using. In default configurations of DirectAccess, there are typically two DTEs, one for the infrastructure tunnel, and one for the user tunnel. You should configure one DTE for each tunnel. Each entry consists of the text PING: followed by the IPv6 address, for example: PING:2001:3039::0001.
Important |
If your DirectAccess configuration uses the Full Intranet Access or Selected Server Access models, where IPsec tunnel mode is used to connect to the DirectAccess infrastructure servers, and a separate IPsec transport mode tunnel is used to access shared resources that are required by the user, configuring one or more servers in the DTE setting is required.